Filter
Top Products
111
Learning the Basics
Using Stand By
5.375 x 8.375 ver 2.4.0
❖ When I close the lid
Set this option to Hibernation for the computer to go
into Hibernation mode when you close the display
panel.
6 Click Override all Modes with settings here.
7 In the Set to range dialog box, do one of the following:
❖ Click DC only for the settings to apply only when
you are using battery power.
❖ Click All for the settings to apply whether you are
using battery power or outlet power.
8 Click OK.
9 Click OK again, then close the Control Panel.
NOTE: For more information about the Power Saver utility, see
“Power Management” on page 197.
Starting again from Hibernation mode
To start the computer from Hibernation mode, press the
power button until the on/off light turns green. The computer
returns to the screen you were using.
If you put the computer in Hibernation mode by closing the
display panel, you can start it again by opening the display
panel.
Using Stand By
To power down the computer using the Stand By command:
1 Click Start, select Turn Off Computer.
The Turn off computer box appears.
2 Click Stand By.