Filter
Top Products
14
ICC
5. Installation
This interface card has been designed for quick and simple installation. The
card is connected to the drive's control board via a 30-pin rectangular
connector, and is mechanically supported via an integral housing that
seamlessly mates with the drive’s enclosure. The only tool required for
installation is a flat-blade screwdriver.
Before opening the drive, please observe all safety precautions as outlined on
the drive's front cover and in the operation manual.
5.1 Installation Procedure
1. CAUTION! Verify that all input power sources to the drive
have been turned OFF and are locked and tagged out.
2. DANGER! Wait at least 5 minutes for the drive’s
electrolytic capacitors to discharge before proceeding to the next step. Do
not touch any internal parts with power applied to the drive, or for at
least 5 minutes after power to the drive has been removed. A hazard
exists temporarily for electrical shock even if the source power has
been removed. Verify that the CHARGE LED has gone out before
continuing the installation process.
3. Remove the drive’s display panel and front cover by inserting a flat-blade
screwdriver into each of the two mounting tab access openings at the top
of the front cover and depressing each of the mounting tabs (Figure 1).
Rotate the top of the font cover outward and remove the cover (Figure 2).
Figure 1: Releasing the Drive's Front Cover