Filter
Top Products
67
ICC
Click OK when done.
Figure 63: Module Properties Connection Tab
6) After adding the I/O Module
to the configuration, the full
I/O Configuration tree should
appear similar to Figure 64.
7) Switch to online mode and download
the project to the PLC. Verify that the
newly-added drive is available and
operating correctly by observing any
indications shown on the drive’s icon.
When the drive’s icon is selected, its
status and any available error
messages will be displayed in the
area below the project tree. Refer to
Figure 65. Also confirm that the
interface card’s “Network Status” LED
should be solid green, indicating an
“online/connected” state.
8) By double-clicking “Controller Tags” in the project tree, it is possible to view
the newly-added tags. Refer to Figure 66. The ASD_G9ETH:C
configuration tag is unused, the ASD_G9ETH:I tag allows viewing of the
input data, and the ASD_G9ETH:O tag allows modification of the output
data. These tags will be synchronized with the drive at whatever rate was
established for the module’s RPI.
Figure 64: I/O Configuration Tree
Figure 65: Online Module Status