Filter
Top Products
28
ICC
currently-selected group does not have any available subgroups, then only the
“All” subgroup will be shown, and all parameters in that group will be shown in
the Parameter List.
10.4.4 Parameter List
The bottom half of the Monitor tab contains the parameter list (refer to Figure
13). The parameters that are displayed in the list at any given time depend on
the group/subgroup selected, as well as whether or not any filters have been
applied (refer to section 10.4.5).
The first two columns of the Parameter List show the parameter name and the
register number that provides access to that parameter, and were discussed in
detail in section 9. The third column contains the parameter descriptions, which
are used by the filter function. The last column performs two functions: it
displays the current value of the parameter, and also allows changing the
parameter’s value by clicking on the number in the value column and entering
the new value.
Figure 13: Parameter List
Some items to keep in mind when interacting with the Parameter List are:
• When entering new parameter values, be sure that the number being
entered is appropriate for the currently-selected radix (refer to section
10.4.6): for example, an entered value of “1000” in hexadecimal is equal to
4096 in decimal.
• If desired, the column widths can be changed by dragging the vertical bars
that separate the header row’s cells to a different position.
• If you begin changing a parameter value and then decide to abandon the
change, pressing the ESC key on your keyboard will abandon the change
and redisplay the current parameter value.
• When editing a parameter value, clicking someplace off the entry cell is
equivalent to hitting the ENTER key.