Filter
Top Products
Appendix 5 System Mode
95
Specifying the Print Condition for the Print Head Adjustment
The print condition for the X/Y Direction Alignment Test should be
specified before printing.
Press the PAUSE key. “PRINT DENSITY” appears. Press the
FEED key again.
Press the PAUSE key.
Print conditions are ready to be set. Press the PAUSE key.
The number of copies for the X/Y Direction Alignment Test can
be selected, with a maximum of ten.
After selecting the value, press the PAUSE key.
Select the print speed options for printing out the X/Y Direction
Alignment Test: 6 inches/second or 4 inches/second.
After selecting the speed, press the PAUSE key.
Select the media sensor to be used for printing out the X/Y
Direction Alignment Test: “TRANS” (Transmissive Sensor),
“REFLECT.” (Reflective Sensor) or NONE.
After selecting the media sensor, press the PAUSE key.
Specify whether a back feed will be performed when printing the
X/Y Direction Alignment Test. Select “YES” for back feeding.
After selecting the back feed option, press the PAUSE key.
The message returns to “<2> PARAMETER SET”.
Note:
Use the FEED or RESTART key
to select a desired value or option.
PRINT DENSITY
HEAD ADJUST
PRINT CONDITION
ISSUE COUNT 5
PRINT SPEED 6"/S
SENSOR TRANS
BACK FEED YES
A5.4 Parameter
Setting (Cont.)