Filter
Top Products
- 114 -
Explanation (1) Number of labels to be issued
If increment/decrement is not specified, the designated number of pieces with
the same drawing data will be issued.
If increment /decrement is specified, the designated number of pieces will be
issued while incrementing/decrementing the piece of the designated drawing
area.
* The increment/decrement designation is valid until the Image Buffer Clear
Command ([ESC] C) is transmitted.
(2) Cut interval
The cut interval is valid only when the cutter has been installed and the issue mode
is “C”. If an error occurs during an issue after the cut interval is designated, and
then printing is restarted, the printer ejects the printed paper then resumes printing
on the paper where the error occurred.
If no subsequent command is received from the PC for 3 seconds after cut-issuing
the last label, when the cut interval is valid and “with automatic forward feed
standby” set in the system mode, the printer automatically performs a 10-mm
forward feed.
When the Issue Command is received during the automatic forward feed standby,
an issue is started after a reverse feed to the original position.
If any command is sent and processed after the Issue Command is sent, the
automatic forward feed is not performed. Therefore, a command should not be
sent after the Issue Command is sent. If the power should not be turned off then
on, or the printer should not be placed in a pause/reset state before the automatic
forward feed, since the automatic forward feed is not performed when the paper is
fed by turning the power off then on, or by pressing the [FEED] key of the printer in
the pause/reset state.
If the paper is fed by pressing the [FEED] key of the printer during the forward feed
standby, the printer feeds one label, cuts, performs the automatic forward feed
then stops.
(3) Type of sensor
No sensor: Printing takes place according to the parameter designated by the
Label Size Set Command.
Reflective sensor:
Printing takes place according to the parameter designated by the Label Size
Set Command. However, the black mark provided on the back side of the tag
paper is automatically sensed by the reflective sensor and the paper position is
finely adjusted for every piece.
Transmissive sensor (when using normal labels):
Printing takes place according to the parameter designated by the Label Size
Set Command. However, the label-to-label gap is automatically sensed by the
transmissive sensor and the paper position is finely adjusted for every piece.