Filter
Top Products
- 10 -
5. TRANSMISSION SEQUENCE
This section describes the outline of the transmission sequence.
5.1 INITIALIZATION
Writable characters, logo, and PC interface commands must be stored before the label issue
operation.
(1) Storing writable characters and logo
NOTES: (1) The storage of PC commands is only performed if it is required.
(2) When the flash memory board is used, and the Memory board Format Command is not
sent before storing already stored writable characters or logos, memory will be taken up
with every such storing.
(3) When the flash memory board is used, and another operation (storing PC interface
commands or label issue operation) is performed after storing writable characters or
logos, the image buffer will be cleared automatically.
(4) If another storing operation does not take place after storing writable characters or
logos, the printer automatically enters the online mode (label issue operation) after
about 10 seconds. In this case, when the flash memory board is used, the image buffer
will be cleared automatically.
Power ON
<New>
Memory board
Format Command
Bit Map Writable
Character Command
Yes
(Add/change)
[ESC] J1: Formats the flash memory on the
memory board.
Completion of storing
all characters
Storing PC interface commands
Label issue operation
No
Yes
[ESC] XD: Stores writable characters or a
logo on the flash memory board.
No