Filter
Top Products
- 60 -
(4) When the drawing data is changed per label issue during printing, the field of the
drawing data for the previous label is automatically cleared using the character
string number, then the next drawing data is printed. Therefore, the character
string number which differs according to the drawing fields should be designated.
Since the automatic field clear is not performed between the Clear Command
([ESC] C) and Issue Command ([ESC] XS), the fixed data may be drawn using the
same character string number. In this case, the Format Command and Data
Command should be sent alternately. (After the Issue Command is sent, the fields
with the same character string number are automatically cleared until the Clear
Command is sent.)
(5) When characters overlap due to the character-to-character space fine adjustment,
the outline font is not painted properly. Program the fine adjust value so that
characters will not overlap. Also, when drawings such as lines or characters are
on the outline font drawing position, the outline font is not painted properly. For
font types A and B, the fine adjustment value should be set so that other drawings
do not overlap the area in which the outline font is to be drawn. For font types C,
E, F and G, the fine adjustment value should be set so that other drawings do not
overlap the area for the designated character width and height.
(6) The link field designation is cleared by omitting the link field designation using the
same character string No. and reformatting data.
The link field designation can be also cleared by the Image Buffer Clear
Command.
(7) A print data string and link field No. cannot be programmed at the same time.
(8) The same character string number cannot be programmed more than once in one
format (one page).
Refer to Outline Font Data Command ([ESC] RV)
Bit Map Font Format Command ([ESC] PC)
Bar Code Format Command ([ESC] XB)