Toshiba GC10-QM Barcode Reader User Manual


 
- 90 -
(3) More than one Bar Code Format Command can be connected when transmitted.
[ESC] XB01; 0100, 0150, 3, 1, 02, 02, 06, 06, 02, 0, 0150 [LF]
B02; 0350, 0150, 3, 1, 02, 02, 06, 06, 02, 0, 0150 [LF] [NUL]
(4) When the drawing data is changed per label issue during printing, the field of the drawing
data for the previous label is automatically cleared using the bar code number, then the next
drawing data is printed. Therefore, the bar code number which differs according to the
drawing fields should be designated. Since the automatic field clear is not performed
between the Clear Command ([ESC] C) and issue Command ([ESC] XS), the fixed data may
be drawn using the same bar code number. In this case, the Format Command and Data
Command should be sent alternately. (After the Issue Command is sent, the fields with the
same bar code number are automatically cleared until the Clear Command is sent.)
(5) The link field designation is cleared by omitting the link field designation using the same bar
code No. and reformatting data.
The link field designation can be also cleared by the Image Buffer Clear Command.
(6) A print data string and link field No. cannot be programmed at the same time.
(7) The same barcode number cannot be programmed more than once in one format (one
page).
Refer to Bit Map Font Format Command ([ESC] PC)
Outline Font Format Command ([ESC] PV)
Bar Code Data Command ([ESC] RB)