Filter
Top Products
- 144 -
Notes (1) No matter what character set or character code is selected, no memory will be
wasted.
(2) When a new writable character is stored, the Flash Memory board Format
Command ([ESC] J1) must be transmitted.
(3) A character code already stored can be stored in the flash memory board again if
the Writable Character Command ([ESC] XD) is transmitted, but memory will be
consumed with every storage. Memory can be efficiently used by sending the
Format Command ([ESC] J1) before storing.
(4) If a flash memory card is used, and a label issue operation is performed after
sending the Bit Map Writable Character Command ([ESC] XD), the image buffer is
cleared automatically.
(5) When the storing operation stops after storing the writable character and logos, the
printer automatically enters the online mode (label issue operation) after about 10
seconds. In this case, when the flash memory board is used, the image buffer will
be cleared automatically.
Refer to Flash Memory Board Format Command ([ESC] J1)