Filter
Top Products
4.9 SW membrane 4 Replacement Procedures
4.9 SW membrane
Removing the SW membrane
To remove the SW membrane, follow the steps below and refer to Figure 4-16.
1. Disconnect the SW membrane cable from the connector CN3250 on the system
board.
2. Push the latch A in the direction in the following figure and lift up the flexible cable
portion of SW membrane from the slot.
3. Push down the latch B and slide the SW membrane in the direction in the figure.
4. Remove the SW membrane.
SW membrane cable
SW membrane
CN3250
Flexible cable
Latch A
Latch B
Portion A
Figure 4-16 Removing the SW membrane
Installing the SW membrane
To install the SW membrane, follow the steps below and refer to Figure 4-16.
1. Place the SW membrane in the slot.
TECRA M5 Maintenance Manual (960-542) [CONFIDENTIAL] 4-27