Filter
Top Products
54
NETWORK SETUP
Network Setup allows the user to adjust settings such as Ports, setup emergency PPP information for use with the Emergency Agent and
enable Remote Access.
View IP Address Displays the IP address of the recorder.
Transport Rate Throttles the bandwidth on the recorder. This option is based on percentages of images sent.
Resolution By setting the resolution low, the images will be sent faster. However, the image quality will be reduced considerably. When
set to Original, full quality video will be sent [720 x 480 (NTSC 720 x 576 (PAL)]. The Original Setting is very bandwidth-intensive.
Time Out Value When attempting to connect to the recorder, if the connection does not succeed during the timeout period (seconds), the
connection will be terminated.
Emergency Port Used to connect with the Alarm Monitor software.
Center Port Used to connect with the Surveillix remote software (Remote, SCS, MDVR). This port must be specified in the remote
software to connect to the recorder.
Note Center Port 1025 is not available.
Image Port Used to transfer the video to the remote software.
Search Port Used to transfer search information to the remote software.
Note If connecting to the recorder through a firewall, the above ports must be open to incoming and outgoing traffic.
Health Check Port Enables SCS to receive information regarding the health of the recorder.
Keyboard control Select the Use Keyboard Control check box to enable use of a connected RS-232 PTZ Joystick/Keyboard.
Two-Way Audio Communication Select the Enable Audio Communication check box to enable two-way audio between the DVR and
SCS using a microphone connected to the DVR.
Use with Emergency Agent
Enable two-way audio between DVR
and Remote Client
Remote Client Ports