Filter
Top Products
78
PAN /TILT / ZOOM OVERVIEW
The PTZ controls within the recorder allow for powerful control over the cameras. This can be extremely beneficial to you by increasing
the usefulness of the recorded video. Using the PTZ controls, you can create custom preset configurations that can continuously sweep
across large areas.
Note PTZ setup and control is only available for supported video encoders with a PTZ RS-485 pass-through.
Enable the PTZ Settings
1. Inside the recorder PTZ Setup, select the PTZ camera using the Camera Channel list.
2. Enable the PTZ functions of the camera by selecting the Enable Pan/Tilt check box.
3. Select the appropriate Protocol and set the PTZ Driver Address and Serial Port Settings (See Advanced PTZ Setup in this
chapter).
Note The majority of major PTZ manufacturer protocols are included in this software. Refer to the Supported Protocols list in this
manual.
4. Click Apply, then click Exit.
5. From the Display screen, click PTZ. The PTZ Controller will open.
6. Select the PTZ camera to control by clicking on the display screen. The camera number will appear inside the PTZ controls.
7. You can now move the PTZ camera using the PTZ controls.
ADVANCED PTZ SETUP
Note Preset and tour options may vary depending on the camera
Adjust Speed Settings
Connection Settings