Filter
Top Products
4.10 Bluetooth module 4 Replacement Procedures
4.10 Bluetooth module
Removing the Bluetooth module
To remove the Bluetooth module, follow the steps below and refer to Figure 4-16.
1. Remove the following screw securing the Bluetooth module.
• M2×3C S-FLAT HEAD screw x1
2. Disconnect the Bluetooth flat cable from both the Bluetooth module and connector
CN4400 on the system board.
3. Disconnect the Bluetooth antenna cable from the Bluetooth module.
M2×3C S-FLAT HEAD
Bluetooth antenna cable
Bluetooth flat cable
CN4400
Bluetooth module
Figure 4-16 Removing the Bluetooth module
Installing the Bluetooth module
To install the Bluetooth module, follow the steps below and refer to Figure 4-16.
1. Connect the Bluetooth antenna cable to the connector on the Bluetooth module.
2. Connect the Bluetooth flat cable to both the Bluetooth module and the connector
CN4400 on the system board.
3. Install the Bluetooth module along the guide and secure it with the following screw.
• M2×3C S-FLAT HEAD screw x1
PORTEGE R200 Maintenance Manual (960-519) [CONFIDENTIAL] 4-27