Filter
Top Products
4.27 Fluorescent Lamp 4 Replacement Procedures
4.27.1 Replacing the 12.1 Inch TMD fluorescent lamp
The following describes the procedure for replacing the fluorescent lamp (See Figure 4-38 to
4-47).
Disassembling the module
1. Peel off tapes and insulating sheets.
1) Place carefully the module face up on a clean and flat worktable. To avoid
scratching the face of the LCD module, make sure the table is free of dirt and dust.
Place a protection sheet (soft cloth or similar one) over the front of the module.
2) Remove the items indicated by the diagonal line in the figure below.
CAUTION: 1) Be careful not to damage the TAB, PCB, B/L and reflection sheet.
2) Leave the insulation sheet on the bezel to reuse later.
3) When peeling off the double-adhesive tape of the insulation sheet, be
careful not to damage the TAB and PCB.
Production label
Insulator sheet
Insulation sheet, double-adhesive tape
Tape of the bezel side
Figure 4-38 Replacing TMD fluorescent lamp(1)
PORTEGE R200 Maintenance Manual (960-519) [CONFIDENTIAL] 4-55