Filter
Top Products
4 Replacement Procedures 4.27 Fluorescent Lamp
5. Screwing the PCB and the bezel
1) Use two screws to secure the left and right edge in the figure below.
CAUTION: 1) The screw tightening torque is 0.167N·m (1.7kgf·cm) for all screws.
2) Use a Philips screwdriver with type 0 bit.
6. Installing the tapes and insulation sheets
1) Stick the double- adhesive tape of the insulation sheet.
CAUTION: 1) Refer to the figure below.
2) When sticking the insulation sheet, be careful not to damage the PCB, cell
and B/L.
Production sheet
Stick the double-adhesive tape of the
insulation sheet to the edge of the PCB.
Figure 4-47 Replacing TMD lamp(10)
4-64 [CONFIDENTIAL] PORTEGE R200 Maintenance Manual (960-519)