Filter
Top Products
4.9 Keyboard 4 Replacement Procedures
Installing the Keyboard
To install the keyboard, follow the steps below and refer to Figure 4-14 to 4-17.
1. Place the keyboard face down on the palm rest and connect the keyboard flexible
cable to the connector CN3230 on the system board.
2. Set the KB support plate and slide it.
3. Secure the KB support plate with the following screw.
• M2.5×10B FLAT HEAD screw ×1
CAUTION: Do not put the keyboard flexible cable on the KB support plate.
Fold down the keyboard flexible cable as shown in the figure below.
Keyboard flexible cable
4. Turn the keyboard face up and set it in place. Extra portion of the keyboard cable must
be put under the KB support plate.
5. Secure the keyboard with the following screws.
• M2.5×4B FLAT HEAD screw ×2
6. Set the KB holder and press to secure the latches (front and back).
TECRA A10/S10/P10/SatellitePro S300 Maintenance Manual (960-684) [CONFIDENTIAL] 4-31