Filter
Top Products
4 Replacement Procedures 4.15 Speaker
3. Remove the speakers (left and right) from the speaker slots while pushing the guides
and speaker harness from the slot.
Speaker
(blue&black harness)
Speaker harness
Speaker
(red&white harness)
Guide
Guide
Figure 4-27 Removing the speaker (2)
Installing the Speaker
To install the speaker, follow the steps below and refer to Figure 4-25 to 4-27.
1. Install the speakers (left and right) to the speaker slots.
2. Turn up the insulators and arrange the speaker cables into the slot.
3. Connect the speaker harness to the connector CN6150 on the system board.
4. Stick the three insulators (SQUARE INSULATOR) in place.
4-46 [CONFIDENTIAL] TECRA A10/S10/P10/SatellitePro S300 Maintenance Manual (960-684)