Filter
Top Products
4.36 Fluorescent Lamp 4 Replacement Procedures
Assembly of outside tape/Cover shield
1. Assembly of Cover shield (S)1.
CAUTION: Pressure or stress should not be given on Source PCB. Usage of gloves with
anti-electric discharge coating is recommended to eliminate possible
damage on circuits occurred by ESD.
2. Assembly of Tape Adhesive2 used for Top case fixing.
CAUTION: Pressure or stress should not be given on Top case during this process.
3. Assembly of Tape Adhesive3 used for Top case fixing.
Assembly of Tape Adhesive4 used for B/L Wire fixing
CAUTION: Pressure or stress should not be given on Top case during this process.
Figure 4-76 Replacing 15.4-inch LG fluorescent lamp (WXGA) (8)
TECRA A10/S10/P10/SatellitePro S300 Maintenance Manual (960-684) [CONFIDENTIAL] 4-119