Filter
Top Products
O
PERATING
B
ASICS
4-7
Using optical media drives
4. Lay the CD, label side up, in the drawer.
NOTE: When the drawer is fully opened, the edge of the computer will
extend slightly over the CD tray. Therefore, you will need to turn the CD
at an angle when you place it in the tray. After seating the CD, however,
make sure it lies flat, as shown in figure 4-8.
CAUTIONS: 1. Do not touch the laser lens. Doing so could cause
misalignment.
2. Be careful to keep foreign matter from entering the
drive. Check the back edge of the tray to make sure it
carries no debris before closing the drive.
5. Press gently at the center of the CD until you feel it click into place. The CD
should lie below the top of the spindle, flush with the spindle base.
Figure 4-8 Inserting a CD