Filter
Top Products
38Chapter 9 . Bandwidth Control
1 ) IP Range: Enter the IP address. The field can be single IP address or IP address range according
to your demands. When you configure the single IP address, the computer with this IP
address will get independent given bandwidth. When you configure the IP address range, all
computers in the range will share the given bandwidth.
2 ) Port Range: Keep the default settings. The default port range of TCP protocol or UDP protocol
is from 1 to 65535.
3 ) Protocol: Keep the default setting. Or you can choose the TCP protocol or UDP protocol or
both of them.
4 ) Priority: Keep the default setting. You can change the value if you want to first guarantee the
bandwidth for one computer. The smaller value has the higher priority.
5 ) Upstream/Downstream: Enter the bandwidth according to your division.
6 ) Check to enable this entry and click OK to save the settings.
6. Follow the steps above to add a rule for the other computer. And then you will get the following
table.
Now you and your roommate have an independent bandwidth.
Done!