Filter
Top Products
123
Using the BCD996T with a GPS
4 Set Type JF At this level you have an opportunity to reassign or edit the
location type you first selected and set the location to either one of the other types
or change the data in an existing location.
4 Set LocationInfo JF Input the latitude and then the longitude.
4 Set Lockout JF As you near your target location, an alert sounds at 0.5,
0.25, and 0.1 mi. You can stop this operation by pressing [L/O]. All the data is
retained.
You can use the menu Lockout option as well. Set the location system to
Temporary L/O so you can move away more than four miles and then come
back again. At that time, L/O status is automatically canceled.
If you turn off the switch, the scanner is unlocked.
For POI Only
4
Set Alert Beep JF Choose Off so no tone sounds or one of the four
alert melodies Alert 1 to Alert 4.
Once you make a Tone selection you are immediately asked to assign a volume
level to that selection.
Set Alert Volume
JF Select from 15 sound levels, plus Auto and Off. As
you rotate the Scroll Control the Alert tone you set is played louder and louder.
Press
F to select a volume level. You can also select Auto, a level that is the
same setting as your master volume control.
4 Set Range JF Input how far away the alert sounds for the site (only
available for POI’s and between .1 and 2.0 miles)
For Dangerous Xing, and Dangerous Road Only
The Alert Tone is fixed. The alert range is auto-set at .5, .25, and .1 mile.
4 Set Alert Volume JF Select from 15 sound levels, plus Auto and Off. As
you rotate the Scroll Control the Alert tone is played louder and louder. Press
F
to select a level you want. You can also select Off (no sound) or Auto, a level
that is the same as your master volume control.
For Dangerous Xing and Dangerous Road sites there are two additional settings: