Uniden SC230 Scanner User Manual


 
38
Basic Operation
3. Rotate the scroll control to select the channel you
want to lock or unlock.
4. Press L/O to lock or unlock the channel.
You can also lock out an active channel by pressing L/O
while the scanner is stopped on the channel.
Temporarily Holding On a System
To temporarily hold on a system, press and hold .
To hold on a different system, continue to hold and
rotate the scroll control to select the system. Normal
scanning resumes 2 seconds after you release .
Holding On a Channel
To hold on a channel, press Hold while the channel is
active. To select a different channel, rotate the scroll
control. If you scroll past the beginning or end of the
current system, the scanner selects channels in the
previous or next system. To resume scanning, press Scan.
Note: If the scanner is set to its race mode, you can select
only unlocked channels. You can select any channel
(locked or unlocked) if the scanner is set to its
conventional mode.
Quick-Storing Channels
1. Hold on an existing channel in any system.
2. Enter the frequency you want to store.
3. To quick-store the channel, press E. Otherwise, press
No.
If you enter a frequency then press E, the scanner
stores it in the Qck Save Grp group in a system called
Qck Save Cnv Sys. These are created if they do not
exist. Then, the scanner prompts you to save other
channel settings.
If you pressed No in Step 3, the scanner prompts you
to select the system and the group where you want to
store the frequency.
Func
Func
Func
SC230 Paper OM.fm Page 38 Wednesday, October 6, 2004 10:51 AM