Filter
Top Products
COURIER HIGH SPEED MODEMS
6-6 Queries and Help Screens
Unable to Retrain: After several attempts, disturbances on
the phone line prevented the modems from retraining, and
they could no longer transmit or receive data.
XID Timeout: The modems failed to negotiate the V.42
Detection (XID Exchange) phase.
Dial Security Disconnect Reason: Possible reasons the
answering modem may have hung up during a Dial Security
session are as follows:
Security Abort: The modem hung up because it received an
invalid password three times.
Prompting Not Enabled: The modem hung up because the
originating modem did not send an autopass password, and
prompting wasn't enabled.
No Prompting in Sync: The originating modem did not send
an autopass password, and the answering modem cannot
prompt for a password in any synchronous mode.
Non-ARQ Mode: The modem hung up because the
originating modem was set for error control and the
answering modem was set for non-error control.
Mode Incompatible: The modem hung up because both
modems were not set to the same error control setting.
No Prompting in Non-ARQ: Prompting was enabled, but the
modem hung up because the originating modem was set for
error control, and the answering modem was set for non-
error control. The answering modem cannot prompt when it
is set for non-error control.
I7 The modem returns a product configuration. If you have a
problem and call U.S. Robotics' Technical Support staff, you
may be asked to read this screen.
I8 Not used
I9 Not used