Filter
Top Products
COURIER HIGH SPEED MODEMS
6-10 Queries and Help Screens
Dialing (D$)
At ATD$, the Courier displays this Dial command summary:
atd$
HELP, Dial Commands (CTRL-S to Stop, CTRL-C to Cancel)
0-9 Digits to Dial
* Auxiliary Tone Dial Digit
# Auxiliary Tone Dial Digit
T Tone Dialing
P Pulse Dialing
R Call an Originate Only Modem
, Pause (Wait for S8 Time)
; Remain in Command Mode After Dialing
" Used to Dial Alpha Phone #'s
W Wait for 2nd Dial Tone (X3-X7)
@ Wait for an Answer (X3-X7)
! Flash Switch Hook
OK
Figure 6.7Sample Dial Command HELP Screen
S-Register Functions (S$)
At ATS$, the Courier displays a screen that shows a partial
summary of the S-Register functions. More screens, activated
by pressing any key, show the remaining registers. The first
screen is as follows.
ats$
HELP, S Register Functions (CTRL-S to Stop, CTRL-C to Cancel)
S0 Ring to Answer On S33 Reserved
S1 Counts # of Rings S34 Bit Mapped
S2 Escape Code Char 1 = Disable V32bis
S3 Carriage Return Char 2 = Disable Enhanced V32 mode
S4 Line Feed Char 4 = Disable Quick V32 retrain
S5 Backspace Char 8 = Enable V23 Fallback
S6 Wait Time/Dial Tone (sec) 16 = Change MR to DSR
S7 Wait Time/Carrier (sec) 32 = Enable MI/MIC
S8 Comma Time (sec) 64 = Disable RA Busy Msg
S9 Carrier Detect Time (1/10sec) 128 = Disable Terbo
S10 Carrier Loss Time (1/10sec) S35 Reserved
S11 Dial Tone Spacing (msec) S36 Reserved
S12 Escape Code Time (1/50sec) S37 Reserved
S13 Bit Mapped S38 Disconnect Wait Time (sec)
1 = Reset On DTR Loss S39 Reserved
2 = Do Originate in Auto Answer S40 Reserved
4 = No Pause Before Result Codes S41# of Allowed Login Attempts
8 = Do DS0 On DTR S42 Remote Escape Code Char
16 = Do DS0 On Reset S43 Remote Escape Code Time (1/50sec)
Strike a key when ready . . .
Figure 6.8Sample S-Register HELP Screen