Filter
Top Products
180ViewSonic Pro9500
6.4 Transmission method
6.4.1 HALF-DUPLEX
The transmission method can be selected from the menus, only when the
NETWORK BRIDGE is selected for the COMMUNICATION TYPE.
(OPTION menu > SERVICE > COMMUNICATION in the Operating Guide)
HALF-DUPLEX FULL-DUPLEX
This method lets the projector make two way communication, but only one
direction, either transmitting or receiving data, is allowed at a time.
The method does not allow the projector to receive the data from the computer
while waiting for response data from an external device. After the projector
receives the response data from an external device or the response limit time is
past, the projector can receive the data from the computer.
That means that the projector controls transmitting and receiving the data to
synchronize the communication.
To use the HALF-DUPLEX method, set up the RESPONSE LIMIT TIME following
the instructions below.
Using the RESPONSE LIMIT TIME menu, set the waiting time for response data
from an external device. (OPTION menu > SERVICE > COMMUNICATION in
the Operating Guide)
OFF 1s 2s 3s ( OFF)
6. Network Bridge Function
RS-232C
RS-232C cable
External device
Ethernet
LAN cable
Computer
Protocol change
TCP/IP data Serial data
Transmitting data
Discarding data
Transmitting data
Response limit
time
Transmitting data
Response data
Response data