Filter
Top Products
Setting input ports using menu
251ViewSonic Pro9500
5.4 Setting the menu
If Intellectual Stack with RS-232C connection is used, observe the followings.
When inputting image signals to Sub via Main, the operations differ between using
computer signals and video signals such as component and video signals.
Inputting image from Main to Sub - Computer signal
1.
If the STACK menu is already displayed on the screen, proceed to 3 below.
Otherwise press the MENU button on the remote control.
If the MENU dialog is displayed, use the ▲/▼ buttons to
highlight MAIN, and press the ► button. A menu will be
displayed.
If the MENU dialog is not displayed, the STACK menu will appear.
2.
Use the ▲/▼/◄/► buttons to go into the following menu.
ADVANCED MENU > OPTION
> SERVICE > COMMUNICATION > STACK
STACK menu will appear on screen. (Oper-
ating Guide → OPTION menu)
3.
Use the ▲/▼ buttons to highlight SUB INPUT
SOURCE, and press the ► button to display the
SUB INPUT SOURCE dialog.
4.
Use the ▲/▼ buttons to highlight FIXED (COMPUTER IN 1), and press the ►
button to complete the setting.
5.
Press the COMPUTER or VIDEO button on the
remote control or the INPUT button on the control
panel of the Main projector, the MAIN INPUT
SOURCE dialog is displayed on screen. Use the
▲/▼ buttons to highlight the port to which the sig-
nal cable is connected, and press the ► button to
complete the setting.
NOTE • When FIXED (COMPUTER IN 1) is selected, the MONITOR OUT
setting is invalid. (Operating Guide → SETUP menu)
• When FIXED (COMPUTER IN 1) is selected, input sources other than
COMPUTER IN1 and COMPUTER IN2 cannot be selected.
• When FIXED (COMPUTER IN 1) is selected, if any button for setting the
input ports including COMPUTER, VIDEO, MY SOURCE/DOC.CAMERA and
MY BUTTON (assigned with input source related functions) buttons on the
remote control and the INPUT button on the projector is pressed, the dialog for
selecting the input source will be displayed.