Filter
Top Products
THE ONETOUCH PANEL 31
THE ONETOUCH PANEL
Use the OneTouch Panel when you want to change the scan settings or
reset the scanner’s hardware properties. If AutoLaunch is off, you can
also scan from the OneTouch Panel. See the section, “Scan from
OneTouch when AutoLaunch is Off” on page 127.
1. To open the OneTouch Panel, press the button on the side of the
scanner, or click the OneTouch icon.
2. The OneTouch Panel opens with the details of the current settings.
3. Click the green arrows at the top left of the Panel to switch between
the panel’s Detail View and Hardware View.
■ The Detail View shows the icon of the Destination Application,
plus the current scan settings. Right-click on the icon to open the
OneTouch Properties window.
■ The Hardware View shows the scanner connected to your
computer. Right-click on the scanner icon to open the Hardware
Properties window. Clicking (not right-clicking) the scanner icon
also toggles back to the Detail view.
4. To close the Panel, click the close button at the top right.
The OneTouch Icon.
The Detail View. The Hardware View.