Filter
Top Products
Watlow EZ-ZONE
®
PM Integrated Controller • 76 • Appendix
Declaration of Conformity
Series EZ Zone PM
Watlow Winona, Inc.
1241 Bundy Blvd.
Winona, MN 55987 USA
Declares that the following product:
Designation:
Series EZ Zone PM (Panel Mount)
Model Numbers: PM (3 or 6)(Any letter or number) – (1, 2, 3 or 4)(A, C, E, F or K)
(A, C, H, J or K)(Any letter or number) – (Any letter or number)
(A, C, E, F or K)(A, D, J or K)(Any two letters or numbers)
Classification: Temperature control, Installation Category II, Pollution degree 2
Rated Voltage and Frequency:
100 to 240 V~ ac 50/60 Hz or 15 to 36 Vt dc/24 V~ ac 50/60 Hz
Rated Power Consumption: 10 VA maximum.
Environmental Rating: Front Panel IP66
Meets the essential requirements of the following European Union Directives by using the relevant
standards show below to indicate compliance.
2004/108/EC Electromagnetic Compatibility Directive
EN 61326 1997 A1:1998
A2:2002
Electrical equipment for measurement, control and
laboratory use – EMC requirements (Industrial Immunity,
Class B Emissions
EN 61000-4-2 1996 A1, A2, 2001 Electrostatic Discharge Immunity
EN 61000-4-3 2002 A1, A2, 2005 Radiated Field Immunity
EN 61000-4-4 2004 Electrical Fast-Transient / Burst Immunity
EN 61000-4-5 1995 A1, A2, 2001 Surge Immunity
EN 61000-4-6 1996 A1,A2,A3, 2005 Conducted Immunity
EN 61000-4-11 2004 Voltage Dips, Short Interruptions and Voltage Variations
Immunity
EN 61000-3-2
2000 ED.2. Harmonic Current Emissions
EN 61000-3-3
1
1995 A1, A2, 2002 Voltage Fluctuations and Flicker
1
For mechanical relay loads, cycle time may need to be extended up to 30 seconds to meet flicker
requirements depending on load switched and source impedance.
73/23/EEC Low-Voltage Directive
EN 61010-1 2001 Safety Requirements of electrical equipment for measurement, control
and laboratory use. Part 1: General requirements
Compliant with 2002/95/EC RoHS Directive
2002/96/EC WEEE Directive Equipment Requires Recycling
Raymond D. Feller III Winona, Minnesota, USA
Name of Authorized Representative Place of Issue
General Manager August, 2007
Title of Authorized Representative Date of Issue
Signature of Authorized Representative
Declaration of Conformity