Filter
Top Products
030-300500 Rev. A 81 October 2006
User Guide
VersaLink™ Gateway (Model 327W)
If you clicked the Public LAN Enable box, the following screen will be displayed, showing the Public LAN Enable
box selected. Click on save.
If you selected Public LAN Enable, or if you made other changes in the Public LAN Configuration screen and
clicked save, the following pop-up screen will be displayed. Click OK to save the new settings. If you click on
Cancel, your new settings will not take effect.
NOTE: DHCP Lease Time value must be greater than 10 seconds. The default = 01:00:00:00. Seconds must be
between 0 and 59, minutes must be between 0 and 59, and hours must be between 0 and 23.
If the settings you have entered in the Public LAN Configuration screen are incorrect, the following warnings
messages may be displayed via pop-up screens. If this occurs, check settings in the Public LAN Configuration
screen.
Warning Message Check Public LAN DHCP Settings
Start Address is not part of the Subnet Check the value in the DHCP Start Address field
End Address is not part of the Subnet Check the value in the DHCP End Address field
End Address is below the Start Address Check the value in the DHCP End Address field
Lease time must be greater than 10 seconds Check the values in the DHCP Lease Time fields