Filter
Top Products
030-300500 Rev. A 84 October 2006
User Guide
VersaLink™ Gateway (Model 327W)
To enable VLAN, click on the box adjacent to the VLAN Enable field. A check mark will appear in the box.
Click on save.
NOTE: For VLAN to function properly, the VLAN ID must be set to a value other than ‘1’ in VLAN
Configuration screen and in the VC 1 Configuration screen when the you are using the Bridge (VLAN Bridge)
protocol. See Advanced WAN section for configuring VC’s (refer to section 12.6.5).
NOTE: If you change the values in the VLAN Configuration screen and click the reset button, the screen will
display the previously set values for the LAN Port you have selected. If you change the settings in this screen, you
must click save to save the new settings.
If you click on save, the following pop-up screen will appear. Click OK in the pop-up screen to allow the new
settings to take effect.