Filter
Top Products
7. Command Echo: Enables/disables command echo. When
enabled, commands sent to the PLS will be echoed back to
your PC, allowing keystrokes to be displayed. To enable
or disable the command echo, type 7, press [Enter], and
follow the instructions in the submenu. (Default = Off.)
8. Inactivity Timeout: Determines how long the PLS will
wait for additional commands. Type 8, press [Enter], and
follow the instructions in the submenu. (Default = 2 Min.)
9. Command Confirmation: When enabled, the PLS will
display a "Sure?" prompt before completing the /A, /B, /D,
/T, and /X commands. When confirmation is "On", the
PLS will also display the status screen after commands are
successfully completed. When disabled, the "Sure?"
prompt is suppressed, and the status screen is not sent
when commands are completed. To enable/disable this
feature, type 9, press [Enter], and follow the instructions
in the submenu. (Default = "On".)
10. Automated Mode: When enabled, the PLS will execute
the /A, /B, /D, /T, and /X commands without displaying the
confirmation prompt, status screen or confirmation
messages. When Automated Mode is enabled, the
password prompt will also be suppressed, and the unit will
always start up in System Mode. This allows the PLS to
be controlled by a device which generates commands to
control A/B switching without human interaction. To
enable/disable this feature, type 10, press [Enter], and
follow the instructions in the submenu. (Default = Off.)
A. Default Parameters: Resets the PLS to default values. In
addition, all menu selected parameters, including circuit
names and passwords will be lost. Note that if Command
Confirmation is disabled, the "Sure" prompt will not be
sent before this command is executed.
Note: If the Default Parameters function is invoked
via the Network Port, the IP Address is not reset. If
this function is invoked via the Console Port or
Modem Port, the IP Address and other network
parameters will be reset.
After defining General Parameters, press [Esc] to exit from the
General Parameters menu.
5-7
Section 5: SetUp and Configuration