Filter
Top Products
6. The Status Screens
The PLS Status Screens are used to display current conditions of
the three switched A/B circuits and the network interface. There
are two status screens; the Circuit Status Screen (/S), and the
Network Status Screen (/SN).
6.1. The Circuit Status Screen
The Circuit Status Screen lists the current A/B settings for the
PLS-345's three switched circuits, and also summarizes user-
selected parameters, such as Command Echo, Inactivity Timeout,
and Command Confirmation.
As shown in Figure 6.1, the Circuit Status Screen lists the
following items:
1. Site ID Message: The currently defined Site ID message.
Note that the site ID message is defined via the General
Parameters Menu (/G).
2. Ckt #: The circuit numbers for the PLS's three A/B
circuits.
6-1
Physical Layer Switch v1.00 Site ID: PLS-345_TEST_IRVINE_CALIFORNIA
CKT# | From | To | POS | MON | Default |
-----+------------------+------------------+-----+-----+---------|
1 | COMMON_LINE_1 | LINE_B1 | B | | A |
2 | COMMON_LINE_2 | LINE_A2 |A|*| A |
3 | COMMON_LINE_3 | LINE_A3 |A|*| A |
-----+------------------+------------------+-----+-----+---------|
Command Echo: On
Inactivity Timeout: 30 Min
Command Confirmation: On
Automated Mode: Off
Monitor Mode: On
Monitor Input Level: 1 - High
"/H" for help.
Figure 6.1: The Circuit Status Screen