Filter
Top Products
6.1. Add Name / Password
To add new User Passwords to the directory, go to the Edit Password Directory Menu (/E), type
1 (Add Name / Password) and press [Enter]. The SRM will display a submenu that contains
the following items:
1. Name: Assigns a Name to each User Password. Note that the SRM will not prompt
callers to enter the User Name in order to log in. This name is used only to associate
each password with a specific client or employee. (Up to 16 characters).
Notes:
• The SRM will not accept duplicate user names.
• The unit will display an error message if you attempt to define a user name that is
already in use.
2. Password: Assigns a Password for each user. When a caller attempts to log on, a valid
User Password must be entered in order to access the secure device.
(Case sensitive, Up to 16 characters.).
Notes:
• The SRM will not accept duplicate User Passwords.
• User Passwords cannot be the same as the existing System Password or Console
Port Password.
• An error message will be sent if you attempt to define a User Password that is the
same as an existing User Password, System Password, or Console Port Password.
3. Dial Back Number: Assigns a Dial Back Number to each User Password. If the Dial
Back Number is not defined, a caller who accesses the SRM with this User Password will
be granted immediate access to the secure device. If the Dial Back Number is defined,
when a caller enters this User Password, the SRM will disconnect, call the Dial Back
Number, and then allow the answering party to access the secure device. (Up to 32
chars.)
Notes:
• The SRM can be configured to perform a Dial Back for some User Passwords,
while providing immediate access to other User Passwords.
• While a Dial Back operation is in progress, the SRM is not able to accept
incoming calls, and will not recognize commands entered via the Console Port.
• If the initial call is not successful, the SRM will repeat the Dial Back procedure as
specified by item 12 (Dial Back Attempts) and item 13 (Dial Back Delay) in the
General Parameters Menu (see Section 5.2).
4. Save Entry: This item stores the Password, Name, and Dial Back Number in the
Password Directory. If you are satisfied with the data entered at prompts 1 through 3,
type 4 and press [Enter] to save this information in non-volatile memory.
After each password is saved, the SRM-100 will redisplay the Add Name/Password menu. To
continue to add names and passwords, repeat steps one through four above. If you have
finished adding passwords, press [Esc] to return to the Edit Password Directory Menu.
6-2
SRM-100 - Secure Rack Modem, User's Guide The Password Directory