Filter
Top Products
7.6.7. Download Parameters
This function is used to save user-selected SRM parameters to an ASCII text file on your PC or
control device. To save SRM parameters, please refer to the instructions in Section 8.1.
7.6.8. Pass-Through Mode (Console-Modem)
The Pass-Through Mode allows communication between the device connected to the Console
Port and the SRM’s modem.
When the Pass-Through Mode is active, the Console Port can access the modem in order to
place outbound calls, or to invoke modem AT commands. For a listing of available AT
commands, please visit our User's Guide archive at http://www.wti.com/guides/guidarch.htm.
Note that when the Command Mode is accessed via modem, the Pass-Through Mode can also
allow a remote user to access a control device connected to the Console Port.
To activate the Pass-Through Mode, proceed as follows:
1. Access the Command Mode as described in Section 5.1.
2. When the "SRM>" command prompt appears, type /U and press [Enter]. The Utilities
Menu will appear as shown in Figure 7.2.
3. From the Utilities menu, type 8, then press [Enter] and follow the instructions in the
submenu.
4. To exit from Pass-Through Mode and return to the Command Mode, type /X and press
[Enter].
7-9
SRM-100 - Secure Rack Modem, User's Guide Operation