Filter
Top Products
Installation
Returning Power Supplies to the Manufacturer
28 Operating Manual for XPR Series Power Supply
Packaging for
Shipping or
Storage
Follow these instructions to prepare the unit for shipping or storage.
1. When returning the unit or sending it to the service center, attach a tag to the unit
stating its model number (available from the front panel label) and its serial
number (available from the rear panel label). Give the date of purchase and an
invoice number, if you have it, as well as a brief description of the problem.
2. For storage and shipping, repack the power supply in its original container. If the
original container is not available, seal the unit in a plastic bag and then pack it
into a wooden or sturdy cardboard box large enough to allow 2 in. (5cm) of
cushioning material to surround the unit. For cushioning, use material such as
foam slabs that are capable of supporting the unit.
3. Label the box as shown below in Figure 2.1.
4. If shipping, mark the service center address and your return address on the
carton.
5. If storing, stack no more than 5 boxes high. Check the storage temperature range
and storage altitude specification in “Environmental Specification” on page 75.
Figure 2.1 Shipping or Storage Carton Label
POWER SUPPLY
Model Number:_______________________
Serial Number: _______________________
FRAGILE — ELECTRONIC EQUIPMENT