Filter
Top Products
1 Before Using the Machine
16 Xerox 6204 Wide Format Solution
Before Using the Machine
1
Product Recycling and Disposal
If you are managing the disposal of your Xerox product, please note that the product
contains lead, mercury, and other materials whose disposal may be regulate due to
environmental considerations in certain countries or states. The presence of lead and
mercury is fully consistent with global regulations applicable at the time that the
product was placed on the market.
A full declaration of the conformity, defining the relevant directives and referenced
standards, can be obtained from your Authorized Local Dealer.
WEEE Directive 2002/96/EC
Application of this symbol on your equipment is confirmation that you
must dispose of this equipment in compliance with agreed national
procedures.
In accordance with European legislation, end of life electrical and
electronic equipment subject to disposal must be managed with agreed
procedures.
Prior to disposal, please contact your local dealer or Xerox
Representative for end of life take back information.
Power Connection
Two power specifications are listed below. The specifications that apply to your
machine depend on your machine configuration and the requirements in your country.
Connect the power plug only to a properly rated and grounded power outlet to avoid
the chance of electric shock. If in doubt, contact your Xerox Customer Support Center.
1. Rated voltage 120 VAC (+/- 10%) @ 12A current
Rated frequency 50/60Hz
2. Rated voltage 220-240VAC (-10% to +6%) @ 10.0A current
Rated frequency 50/60Hz
Ensure that the plug connection is free of dust. In a damp environment, a
contaminated connector can cause connection problems over time.
Do not attempt to rework, pull, bend, chafe, or damage the power cord in any way. Do
not place heavy objects on the cord because that can also damage the cord.
Stop operation immediately if your machine produces smoke, excessive heat, unusual
noises or smells, or if water, coffee, or other liquids are spilled on the machine.
Immediately turn off the machine and unplug it. Then contact your Xerox Customer
Support Center.