Filter
Top Products
2 Product Overview
38 Xerox 6204 Wide Format Solution
Product Overview
2
5 Pinch the lever at the end of the shaft, and insert
the shaft into the new roll media. Be sure the roll
ends align with the media size guide.
6 Adjust the roll media’s orientation, and place the
shaft on the shaft guide.
7 Rotate the roll media until the lead edge is
gripped in the roller.
The roll media will automatically load, and then stop.
Note: If the roll media cannot be loaded correctly because
its lead edge is damaged, trim the lead edge before
setting it in place.
WARNING: Do not open the Roll 1 or the Roll 2 cutter cover unless you are specifically
directed to do so.
8 Press the cutter button to cut the lead edge of
roll media.
The lead edge of the roll media is cut.
Important • Pressing the cutter button one time cuts about
8.3 inches (210 mm) of media from the lead
edge of the roll. When the cutter button is held
down, the roll media feeds continuously until
the cutter button is released. The roll media is
cut when the cutter button is released.
9 Remove the piece of paper that was cut.