Filter
Top Products
Transmission
46
1
E Specify the destination, and then press the {Start} key.
Note
❒ This stamp indicates that the original has been successfully stored in mem-
ory for Memory Transmission, or successfully sent by Immediate Trans-
mission.
❒ When the stamp starts getting lighter, replace the cartridge.
❒ If a multi-page feed or paper jam occurs, the originals are not sent properly
and not stamped. If you find a page that is not stamped, send only that
page again.
❒ You can have the machine select the Stamp function right after the power
is turned on or the {Clear Modes} key is pressed. See “Registering a priority
function using a program”.
❒ You can program one of the Quick Operation keys with operations for this
function. Using the Quick Operation key allows you to omit step
B
.
❒ A paper jam during Parallel Memory Transmission may cause the trans-
mission to fail even if stamping is performed.
❒ You cannot turn the Stamp function on or off while an original is being
scanned.
Reference
p.270 “Registering a priority function using a program”
“Facsimile Features”, General Settings Guide
“Adding Paper, Toner and Staples”, Troubleshooting