Filter
Top Products
FSSDEF FSSNAME=IDAXFC,PROC=IDAXFC,HASPFSSM=HASPFSSM
The following example indicates a JES2 FSS definition for JES2 versions after 4.1.
FSS(IDAXFC) PROC=IDAXFC,
HASPFSSM=HASPFSSM
Note:
When more than one FSS is defined, a
unique PROC name is required for
each definition
2. Generate the JES2 printer definition
The following example indicates a JES2 printer definition for JES2 versions prior to
4.1.
PRT1 FSS=IDAXFC,
MODE=FSS,PRMODE=(LINE,PAGE),
CLASS=J,DRAIN,
UCS=0,
WS=(W,R,Q,PRM,LIM/F,UCS,FCB,P)
The following example indicates a JES2 printer definition for JES2 versions 4.1 or
higher.
/* */
PRT(1) FSS=IDAXFC, /* FUNCTIONAL SUBSYSTEM NAME */
MODE=FSS, /* Started by FSS */
CLASS=J, /* Class */
CKPTPAGE=20, /* Max page before a checkpoint */
DRAIN, /* Drained at initialization */
ROUTECDE=U7, /* Routecode */
UCS=0, /* Ucs */
PRMODE=(PAGE,LINE), /* Printer mode */
WS=(W,R,Q,PRM,LIM/F,UCS,FCB,P)
PRT(2) FSS=IDAXFC,
MODE=FSS,PRMODE=(LINE,PAGE),
CLASS=J,DRAIN,
UCS=0,
WS=(W,R,Q,PRM,LIM/F,UCS,FCB,P)
Consult the relevant JES publications for further information on the above parameters.
To permit the distribution of print to a specific printer unit, a route code definition
should be supplied with the printer definition. This can be performed using the
ROUTCDE= statement.
When a JES2 DESTID statement is also added as shown following, it is possible to
directly address a specific printer with the use of the DEST parameter on the SYSOUT
or OUTPUT statements.
PRT(1) FSS=IDAXFC,
MODE=FSS,
PRMODE=(LINE,PAGE),
CLASS=J,DRAIN,
UCS=0,
WS=(W,R,Q,PRM,LIM/F,UCS,FCB,P),
ROUTECDE=U1111
DESTID(PCPRT1) DEST=U1111
Both FSS and printer definitions can also be dynamically added to JES2 during normal op-
eration. Define the FSS proc first prior to defining any specific printers. The following JES2
commands are indicated as examples only, and will require modifications to meet your in-
stallation requirements. These examples of JES2 operator commands assume the avail-
ability of a PROCLIB member IDAXFC.
ADD FSS(FSS1),PROC=IDAXFC
ADD PRT20,MODE=FSS,FSS=FSS1,MODE=FSS,PRM=(LINE,PAGE),UCS=0,WS=(....
Consult the relevant JES publications for further information on the above parameters.
20 ida XFC Installation Guide