Filter
Top Products
JES3 Installation
Note:
JES3 3.1.3 supports control of up to 32 printers by a single FSS. The actual number
of printers that can be active simultaneously will depend on the processor size and print
workload. Multiple FSS definitions could therefore be required.
The following modifications are required to be included in the JES3 initialization deck to
define an FSS system and any associated printers.
1. Generate the JES3 FSS definitions
The FSSNAME and PROC name in the following example are both assumed to be
IDAXFC.
FSSDEF,PNAME=IDAXFC,FSSNAME=IDAXFC,TYPE=WTR,SYSTEM=SYS1
Note:
When more than one FSS is defined, a
unique PROC name is required on
each definition
2. Generate the JES3 printer definition
DEVICE,DTYPE=PRT3820,JNAME=PRT1,JUNIT=(,SYS1,,ON),
FSSNAME=IDAXFC,MODE=FSS,PM=(LINE,PAGE)
Consult the relevant JES publications for further information on the above parameters.
To permit the distribution of print to a specific printer unit, a route code definition
should be supplied with the printer definition. This can be performed using the
ROUTCDE= statement. When a DESTID statement is also added as shown following,
it is possible to directly address a specific printer with the use of the DEST parameter:
DEVICE,DTYPE=PRT3820,JNAME=PRT1,JUNIT=(,SYS1,,ON),
FSSNAME=IDAXFC,MODE=FSS,PM=(LINE,PAGE),ROUTECDE=U1111
DESTID(PCPRT1) DEST=U1111
CA-Spool Customization
This procedure should only be used where the IDAXFC is to be installed under control of
CA-Spool.
1. Customize the CA-Spool initialization statements to include the IDAXFC
Modification of the CA-Spool initialization statements will be required to define the
idaXFC
and all printers that will be defined to the
idaXFC
. The following example de-
fines a Functional Subsystem called IDAXFC, and adds two printer definitions, for
NODE printer 1 and Node printer 2.
*************************************************************
* E S F X PARAMETER LIST *
*************************************************************
FSSDEF IDAXFC,PROC=IDAXFC
*************************************************************
* DEFNODE DEFINITION *
*************************************************************
NODE PRT1,3812,CLASS=AQ,GROUP=2,PURGE=NO,
ACQUIRE=NO,REST=YES,RELEASE=NO,
AUTO=YES,SETUP=FORM,RDQUERY=NO,
FORM=STD,INITFF=NO,FSS=IDAXFC
NODE PRT2,3812,CLASS=AQ,GROUP=2,PURGE=NO,
ACQUIRE=NO,REST=YES,RELEASE=NO,
AUTO=YES,SETUP=FORM,RDQUERY=NO,
FORM=STD,INITFF=NO,FSS=IDAXFC
ida XFC Spool File Converter Installation Procedure 21