Filter
Top Products
XEROX DOCUPRINT 180 LPS HARDWARE COMPONENTS
3-8 XEROX DOCUPRINT 180 LASER PRINTING SYSTEM PRODUCT GUIDE
Appearing in the message area are the following messages:
• Lines 1 and 2. These lines display the current status of the
printer, for example, READY.
• Line 3. This line displays messages concerning masked
conditions, such as low dry ink. These messages are preceded
by an asterisk.
• Line 4. This line displays messages concerning masked
conditions, such as low dry ink. These messages are preceded
by an asterisk.
The miscellaneous icons that appear in area 12 are as follows:
Hint icon This icon appears when a masked fault or condition exists
in the printer. (Refer to the
Xerox DocuPrint 180 LPS Operator
Guide
, “Fault masking and the printer control console” section.) The
icon also appears on the PC UI.
Fault icon This icon appears only when a fault exists in the system
that stops the printer or prevents it from printing. The icon also
appears on the PC UI.
Guarded tools icon. This icon appears when a maintenance task
requiring a Customer Productivity Workshop (CPW) trained operator
must be done. If you have successfully completed CPW, either check
the PC UI for messages concerning the maintenance task or touch
the Guarded Tools icon to display the Guarded Tools screen. If you
are not a CPW trained operator, notify your lead operator or a CPW
trained operator at your site.
Note: The bypass transport is optional and appears on the printer
control console of those systems that are configured as such.
Attention light
An attention light is mounted on top of the inverter module. (Refer to
figure 3-6.) The attention light can be enabled or disabled. (Refer to
Xerox DocuPrint 180 LPS Operator Guide
for instructions.) When
enabled, the light has three states:
Off No printer problems exist that require your attention.
Steady light A situation exists that needs your attention (such as a low dry ink
condition).
Flashing The printer has stopped and your attention is required immediately.