Filter
Top Products
PRODUCT DIFFERENCES/USER CONSIDERATIONS
XEROX DOCUPRINT 180 LASER PRINTING SYSTEM PRODUCT GUIDE 5-3
Using your Xerox DocuPrint 180 LPS as a backup LPS
Tables 5-1 through 5-6 identify particular job features to consider
when printing a job on your Xerox DocuPrint 180 LPS which was
created on another Xerox LPS running a different software version.
Each table contains specific job features which may be encountered,
the projected results when printed on your Xerox DocuPrint 180 LPS,
and where to find further information.
Table 5-1. Will this 4635 (V3A R1.7) job print on my Xerox
DocuPrint 180 LPS
Job features from 4635
(V3A2 R1.7) Results when run on DP 180 LPS
Programmable bypass
transport
Job prints if DP 180 LPS has a bypass
transport and the finishing device is
required by the job. Otherwise, it does
not run.
Clusters Job prints. Operator needs to redefine
clusters if trays differ.
Edgemarking Job prints
Fonts Job prints if the fonts and character sets
used are loaded on the DocuPrint 180
LPS or if substi-tutions for these fonts
are defined.
Graphics Job prints if sufficient graphic memory is
available.
Labels Job prints using only paper labels. Refer
to the
Xerox DP 180 LPS Operator
Guide
for loading instructions.
Page density Job prints.
Paper sizes Job prints.
Paper stock Job prints if it does not use edge
reinforced 3-hole stock.
Stitch commands No stitcher available on DP 180 LPS,
therefore stitch commands are ignored
and job prints unstitched.
Transparencies Job prints.
MICR A message will appear stating that the
system is not configured for this feature.
Bar Code A message will appear stating that the
system is not configured for this feature.
Interpress A message will appear stating that the
system is not configured for this feature.
XNS A message will appear stating that the
system is not configured for this feature.
Ethernet A message will appear stating that the
system is not configured for this feature.