Filter
Top Products
SYSGEN AND SYSGEN-RELATED PROCEDURES
4-18 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS SYSTEM GENERATION GUIDE
Table 4-5. Steps to perform an online update sysgen
Step Action System Response
1. Load the SST tape or cartridge tape on the
selected peripheral device.
Verify the existence of sufficient disk
space, using the FCHECK command. Each
disk must have a minimum of 3000
contiguous sectors free. If the number of
available sectors is below 3000:
• Compress the disk.
• Back up as many files as necessary to
obtain the minimum number of free
sectors.
• Delete the saved files from disk.
Refer to the
DocuPrint 96/DocuPrint 96MX
LPS Operations Reference
for additional
information.
2. Press the Boot button. The following is displayed:
READY
$
3. Enter BD and press <ENTER>.
NOTE: This step assumes that a version of
the operating system already resides on
the disks. If this is not the case, you must
load a version of the sysgen processor
from tape (by entering BT) and perform a
full or update sysgen.
The command menu displays:
COMMANDS Display commands
BOOT Boot the operating system
SYSGEN Build or update system files on
disk from tape or host
FORMAT Format and initialize disk pack
HOSTCOPY Copy user files from host to disk
AUTO Auto Sysgen
MINI Configuration change only
ERASE Erase all files
4. Enter SYSGEN and press <ENTER>. This starts the current processor sysgen procedure and the
following message displays:
* Sysgen program running *
System ID is: xxxxx
Do you want to enter a new system id? ’y’ or
’n’
5. Enter N to retain the existing ID or Yto enter
a new system ID and press
<ENTER>.
Do you want to save the accounting file?
enter 'y' or ’n'
6. Enter Y or N and press <ENTER>. The base configuration and the system configuration
options are displayed followed by:
Do you wish to make any changes? Enter 'y'
or 'n'
>