Filter
Top Products
f Command - Cut Position
Description Use this command on an individual printer to
provide precision cut placement.
·
Compensate sensor to cutter position differ
-
ences on a printer by printer basis.
·
Fine-tune cut position to compensate for dif
-
ferences in media.
Syntax fp
1
Parameters p
1
= Cut position index measured in dots.
Acceptable values: 070 to 130. The de
-
fault value is 100.
When using the label liner cutter option, the
printer will advance each printed label to the
appropriate programmed offset cut position,
between
labels, before cutting. Due to media
differences, the printer may not accurately
position the labels before cutting, causing the
cutter to cut the label instead of the liner.
The printer’s cutter is not designed to cut labels. La-
bels have adhesive that may interfere with the
proper operation of the cutter.
Only cut label liner and tag stock and do not exceed
the specified media density and thickness of the
cutter.
If the cut position causes the label just printed to
be cut, increase the cut position index value
(>100). If the cut position causes the label fol
-
lowing the one just printed to be cut, decrease
the cut position index value (<100).
3-40
980352-001 Rev.A