Filter
Top Products
P100IH ISDN Router
9-16 Filter Configuration
9.4.2 Remote Node Filters
Go to Menu 11.5 (shown below) and enter the number(s) of the filter set(s) as appropriate. You can cascade
up to four filter sets by entering their numbers separated by commas. The factory default filter set,
NetBIOS_WAN, is inserted in
protocol filters
field under
Call Filter Sets
in Menu 11.5 to block local
NetBIOS traffic from triggering calls to the remote node.
Figure 9-11 Filtering Remote Node traffic
9.4.3 Default Dial-in Filter
Use
Menu 13.1 – Default Dial-in Filter
to specify the filter set(s) to apply to the incoming and
outgoing traffic between all dial-in users and your Prestige. Note that these filter set(s) only apply to the
dial-in users but not the remote nodes. You can specify up to 4 filter sets separated by comma, e.g., 1, 5, 9,
12, in each
filter
field. The default is no filters.
Figure 9-12 Default Dial-in Filter
Menu 13.1 - Default Dial-in Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters= 1
device filters=
Factory Default Filter