Filter
Top Products
P100IH ISDN Router
System Maintenance 11-17
If you upload the firmware to the Prestige, it will reboot automatically when the file transfer is completed
(the SYS LED will flash).
Note that the telnet connection must be active and the SMT in CI mode before and
during the TFTP transfer.
For details on TFTP commands (see following example), please consult the documentation of your TFTP
client program. For UNIX, use “
get
” to transfer from the Prestige to the workstation, “
put
” the other way
around, and “
binary
” to set binary transfer mode.
Example Using the Walusoft TFTP client
Figure 11-20 TFTP Example
11.6.4 Boot module commands
Prestige boot module commands are shown below. For ATBAx, x denotes the number preceeding the colon
to give the console port speed following the colon in the list of numbers that follows; e.g. ATBA3 will give
a console port speed of 9.6 Kbps. ATSE displays the seed that is used to generate a password to turn on the
debug flag in the firmware. The ATSH command shows product related information such as boot module
version, vendor name, product model, RAS code revision, ISDN code revision, etc.
Enter the IP address of the Prestige.
192.168.1.1 is the Prestige default IP
address when shipped.
Enter the path and name of the
firmware file (*.bin extension) or
configuration file (*.rom extension) on
y
our com
p
uter.
Press “Send” to upload the file to the
Prestige and “Fetch” to back up the
file on your computer. Transfer the
file in binar
y
mode.
This is the filename on the Prestige.
The filename for the firmware is
“
ras
” and for the configuration file,
is “
rom-0
”.