Filter
Top Products
P100IH ISDN Router
Hardware Installation and Setup 2-1
Chapter 2:
Hardware Installation & Initial Setup
2.1.1 Front Panel LEDs OF P100IH
The LED indicators on the front panel indicate the operational status of the Prestige 100IH. The following
table describes the LED functions:
PWR
ISDN LAN PHONE
TST
LNK B1 B2 1 2
3
412
ISDN Hub Router
Figure 2-1 Front Panel Of P100IH
Table 2-1 LED functions
PWR
The PWR (power) LED is on when power is applied to the Prestige.
TST A blinking TST (test) LED indicates the Prestige is functioning properly. A steady
or an off TST indicates malfunction.
ISDN: LNK The LNK (Link) LED is on when the Prestige is connected to an ISDN switch and
the line has been successfully initialized.
ISDN: B1/B2 The B1/B2 LED is on when the corresponding B channel is in use.
LAN: 1 to 4 A steady LED indicates an active station is connected to the corresponding port.
The LED blinks when the connected station is transmitting.
PHONE: 1/2 The LED is on when the device on the corresponding phone port is in use.