Filter
Top Products
P100IH ISDN Router
6-4 Remote Node TCP/IP Configuration
Table 6-2 TCP/IP Remote Node Configuration
Rem IP Address This will show the IP address you entered for this remote node
in the previous menu.
Rem IP Subnet
Mask
Enter the subnet mask for the remote network.
My WAN Addr
Some implementations, especially the UNIX derivatives, require the
WAN link to have a separate IP network number from the LAN and
each end must have a unique address within the WAN network
number. If this is the case, enter the IP address assigned to the WAN
port of your Prestige.
Note that this is the address assigned to your local Prestige
WAN, not the remote router. If the remote router is a Prestige,
then this entry determines the local Prestige
Rem IP Address
in menu 11.1 (see
Table 6-1
).
NAT Choose from None, Full Feature or SUA Only. See Chapter 4:
for a full discussion of this new feature.
Address Mapping
Set=
A NAT Server Set is a list of LAN side servers mapped to
external ports (similar to the old SUA menu 15.1 before). You
may enter any server set number up to 10, but the first one is
used foe SUA only.
Metric The metric represents the “cost” of transmission for routing
purposes. IP routing uses hop count as the measurement of
cost, with a minimum of 1 for directly connected networks.
Enter a number that approximates the cost for this link. The
number need not be precise, but it must be between 1 and 15.
In practice, 2 or 3 is usually a good number.
1
to
15
Private This parameter determines if the Prestige will include the route
to this remote node in its RIP broadcasts. If set to
Yes
, this
route is kept private and not included in RIP broadcast. If
No
,
the route to this remote node will be propagated to other hosts
through RIP broadcasts.
Yes/No
RIP
Press the space bar to select the
RIP direction
from
Both
/
In
Only
/
Out Only
.
(Default=
Both
)
Version=
Press the space bar to select the RIP version from
RIP-1/RIP-
2B/RIP-2M.
RIP-1
(default)