Filter
Top Products
P100IH ISDN Router
4-14
NAT
Configuring a Server behind NAT
Follow the steps below to configure a server behind NAT:
Step 1.
Enter 15 in the main menu to go to
Menu 15 – NAT Setup.
Step 2.
Enter 2 to go to
Menu 15.2 - NAT Server Setup
.
Figure 4-13 Menu 15.2 – NAT Server Sets
Step 3.
Enter the index number of the set you want to configure. This brings up menu 15.2.X where X is
the index number.
Step 4.
Enter the service port number in the
Port #
field and the inside IP address of the server in the IP
Address field.
Figure 4-14 Menu 15.2.1 –Multiple Server Configuration
Menu 15.2.2 - Multiple Server Configuration
Port #
----
IP Address
---------------
1
.
Default
0.0.0.0
2.21 192.168.1.33
3.23 192.168.1.34
4.25 192.168.1.35
5.80 192.168.1.36
6. 0 0.0.0.0
7. 0 0.0.0.0
8. 0 0.0.0.0
9. 0 0.0.0.0
10. 0 0.0.0.0
11. 0 0.0.0.0
12. 0 0.0.0.0
Press ENTER to Confirm or ESC to Cancel:
Menu 15.2 - NAT Server Sets
1. Server Set 1 (Used for SUA Only)
2. Server Set 2
3. Server Set 3
4. Server Set 4
5. Server Set 5
6. Server Set 6
7. Server Set 7
8. Server Set 8
9. Server Set 9
10. Server Set 10
Enter Set Number to Edit: